Components
What comes off the machines
Fluid power and flow control account for most of it: bodies, glands, pistons, shafts, bushes and fittings. Each family sets out the materials worked, what will fit, the features cut and how the part is proved.
Hydraulic Valve Bodies and Manifold Blocks
Machined hydraulic valve bodies and manifold blocks, built to print, with cross-drilled porting and sealing faces verified on the CMM.
See the familyCylinder Glands and Pistons
Glands, pistons and end caps for double acting hydraulic cylinders, with seal grooves and sealing lands verified on a contour tester.
See the familyPrecision Shafts with Keyways and Splines
Motor, pump and gear shafts with keyways, splines and induction hardened journals, turned and milled in one clamping.
See the familyMachined Bushes, Glands and Wear Parts
Guide bushes, wear rings and sleeves in steel, bronze and brass, with bores gauged for repeat volumes.
See the familyBrass and Bronze Machined Components
Turned brass and bronze couplers, fittings and bushes, machined from bar with clean thread forms and sealing faces.
See the familyValve Components and Trim
Stems, balls, seats, bodies and adaptors for industrial valve makers, in stainless, duplex and specialty alloys, with seat profiles proved on a contour tester.
See the familyMachined Flanges and Mounting Plates
Faced and bored flanges, mounting plates and actuator adaptors, including ISO 5211 patterns, with the spigot register held concentric to the bore.
See the familyCustom Fasteners and Special Screws
Non-standard screws, studs and knobs turned to drawing, in steel, stainless, brass and specialty alloys, with hardened shanks where the load calls for it.
See the familyWorm Gears, Cages and Flywheels
Worm gears, transmission cages, flywheels and gear blanks, with bores, keyways and faces held true so the drive stays quiet.
See the familyCore Boxes and Foundry Tooling
Matched core box halves, pattern plates and foundry tooling, machined so the split line closes without a step.
See the familyMachined Brackets and Housings
Machined castings, fabrications and brackets, with hole patterns held to true position against the drawing datums.
See the familyAlso machined
Automotive, powertrain and IC engine parts
Hubs in grey and ductile iron, shifter levers and forks forged and induction hardened, rocker arm assemblies built from around 36 components and shipped direct on line, and IC engine brackets from shell moulded castings. Parts calling for IATF 16949 are supplied through Versatile Equipments under its certification.
Send the drawing
A straight answer inside a working day
A 2D or 3D file, the quantity and the date you need it. You will get a considered reply within one working day, including the reply that we are not the right shop for the part, which is worth knowing early. A mutual NDA goes out first if you would rather.